Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Englewood Homeowners
A broken garage door spring leaves the door dead weight, often half-open and stuck. That’s the call we take most often around Englewood, and it’s the repair we take most seriously. A torsion spring holds a load heavy enough to injure anyone working under it without the right tools and training, which is why we treat spring work as a safety-first specialty rather than a general repair. Our technicians have up to 11 years of experience with torsion and extension systems, and they carry the winding bars and winding tools that make the job safe and predictable. Most spring calls in Englewood get same-day service. Call (833) 513-8729 and we’ll get a trained technician to your door.
What Our Garage Door Spring Repair Service Includes
Torsion Spring Replacement
A torsion spring is the coiled spring mounted on the shaft above the door, and it’s what balances the door’s weight through the whole open and close cycle. When a torsion spring snaps, the door becomes almost impossible to lift by hand and may drop hard if someone tries. We replace torsion springs matched to your door’s weight and height so the opener isn’t straining against the wrong tension.

Extension Spring Replacement
Extension springs run along the tracks on either side of the door and stretch as the door closes. They’re common on older Englewood homes and they’re the spring type most associated with dangerous snapback when one fails, which is why a properly rated safety cable matters on every extension spring. We replace extension springs in matched pairs and check the cable runs on both sides while we’re there.

Broken Spring Repair
A broken spring usually announces itself with a loud bang, then a door that won’t open or rises only a few inches before stopping. Attempting to force the door only puts the opener and the panels at risk. When you call us, we identify the failure first, then quote the repair before we touch anything.

Spring Adjustment
Sometimes the spring isn’t broken, just out of balance. A door that feels heavy, jerks on the way up, or drifts back down after you release it by hand is telling you the tension is off. We measure and adjust the spring tension so the door balances and the opener stops working harder than it should.
Safety Cable Installation
Safety cables thread through the center of each extension spring and keep the spring contained if it ever breaks, which is the kind of backup that matters most on a door used every day. Many older doors around Englewood were installed before these cables were standard. We fit rated safety cables as part of extension spring work, and we’ll flag it if your door is missing them.
Spring Inspection
A spring inspection is a hands-off check of the coil, the shaft, the bearings, the cables, and how the door balances through its travel. It’s the right call when you hear a creak, notice a gap in the coil, or just want a straight answer on how much life is left in your system. We tell you what we see and what can wait, and we don’t replace parts that are still doing their job.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
Springs are sized to the door, so the brand on the door tells us a lot about how the system was built and where it tends to wear. We work on Clopay and Amarr doors regularly, and we know how those panels are weighted and what spring pairing they typically ship with. We also service Wayne Dalton and Raynor systems, including the hardware layouts those two use that can frustrate a generalist who only sees them once in a while.
On the opener side, we know the LiftMaster and Chamberlain units that most Englewood garages have, including the myQ smart-home models, plus the Craftsman and Genie units still running in plenty of homes. That matters for spring work because a balanced door is only half the equation; the opener has to be rated for the new spring tension. Whether you have a LiftMaster opener or any other make, we can help, and we’ll tell you honestly if the opener is the next thing to address.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. A torsion spring failing sounds like a gunshot, and it usually happens when the door is at rest. If you heard it and the door won’t open, stop trying and call us.
- The door lifts a few inches and stops. This is the classic broken-spring symptom: the opener can’t lift dead weight. Forcing it burns out the opener motor or strips the gear, so don’t hold the button down.
- The door feels unusually heavy by hand. A balanced door should lift with one hand and stay where you leave it. If it drops or feels like dead weight, the spring tension is wrong.
- A visible gap in the coil. Look at the torsion spring above the door or the extension springs along the sides; a separated coil or a stretched spring means it’s near or past the end of its life.
- The door slams down or jerks on the way up. Jerky travel, a hard close, or a door that hangs unevenly can all trace back to spring tension. It’s worth a look before the opener takes the damage.
Our Garage Door Spring Repair Process – Step by Step
- 1
Safety check and assessment. We start by securing the door and confirming what failed: torsion or extension, one spring or both, and whether the cables and bearings are still sound. This is a hands-off assessment; nobody winds a spring until we know exactly what we’re dealing with.
- 2
Written estimate before any work. You get a clear price for the repair before a single tool comes out. No surprises on the invoice, and no work starts until you’ve agreed to the number.
- 3
Spring removal and replacement. We release the tension with proper winding bars, remove the failed spring, and install a replacement rated for your door’s weight and height. Matched pairs get replaced together so the door stays balanced.
- 4
Balance and cycle test. After the new spring is wound, we test the door by hand through a full cycle, checking that it balances and that the opener isn’t fighting the spring. We adjust tension until the door moves the way it should.
- 5
Final walkthrough. We run the door several times under opener power, check the safety reverse, and show you what we did and what to watch for. If your opener is a LiftMaster or Chamberlain, we’ll confirm its travel limits still match the new spring.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Englewood?
Garage door spring repair in Englewood typically runs $180 – $340 for one spring, depending on the spring type, the door’s size and weight, and whether the job is a clean replacement or involves other hardware. A matched pair is usually replaced together, so a pair costs about twice that range.
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Spring pair (both springs) | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
What affects the price: the spring type (torsion versus extension), the door’s weight and height, whether one spring or a pair is being replaced, and whether the cables or bearings need attention at the same time. To avoid overpaying, get a written estimate before any work starts and ask whether the price covers both springs if your door uses a pair. The written estimate sets the final price. Our free estimate includes the assessment, the parts recommendation, and a clear quote, so you know what you’re paying before we begin.
Garage Door Spring Repair Near Englewood – Our Service Area
We handle spring repair across Englewood and the surrounding south-metro neighborhoods, including Littleton, Greenwood Village, Columbine, Cherry Creek, Lakewood, Centennial, and Highlands Ranch. Response times vary by location and how busy the day is, but most spring calls in and around Englewood get same-day service. If you’re nearby and want the same safety-first approach to your garage door spring repair, we cover that too, and we work the same way throughout the area.
Serving Englewood, CO – Our Local Coverage Area
We serve Englewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Englewood
Garage door spring repair is the replacement, adjustment, or inspection of the springs that counterbalance your door’s weight. Torsion springs mount above the door; extension springs run along the tracks. Both carry stored energy strong enough to cause serious injury if handled without the right tools, which is why this is a job for a trained technician. Call (833) 513-8729 for a free estimate.
Most single-spring replacements take about an hour once the technician is on site; a matched pair or a job that includes cables and bearings can run longer. The assessment and estimate come first, so you’ll know the scope before work begins. We don’t leave until the door is balanced and tested. Call (833) 513-8729 to schedule.
Spring repair in Englewood typically runs $180 – $340 for one spring, with a matched pair costing about twice that range. The final price depends on spring type, door size and weight, and whether other hardware needs attention. Your written estimate sets the final price, and there’s no charge for the estimate itself. Call (833) 513-8729 for an exact quote.
Yes. We service LiftMaster and Chamberlain openers, including the myQ smart-home models, along with Craftsman and Genie units. Spring work and opener work go together, since a new spring changes the load the opener sees. Call (833) 513-8729 and we’ll confirm what your system needs.
Most spring calls in Englewood get same-day service. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. We’re closed Saturday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (833) 513-8729.
Yes, our spring work is backed by a satisfaction guarantee, and we’ll walk you through the coverage on your specific repair before we start. If something isn’t right after the job, call us and we’ll make it right. The written estimate spells out what’s covered. Call (833) 513-8729 with any questions.
Clear the area under and around the door so the technician has room to work, and don’t try to lift or force the door before we arrive. If you can, note what you heard or saw when it failed (a bang, a gap in the coil, a door that stopped halfway) since that helps us diagnose faster. Have your opener brand and model handy if you know it. Call (833) 513-8729 to book.
Schedule Your Garage Door Spring Repair Service in Englewood Today
Don’t force a door with a broken spring. Call Englewood Garage Door Repair Pros at (833) 513-8729 and we’ll get a trained technician out to assess it, quote it, and fix it right, with the price agreed before any work starts. Our free estimate comes with no obligation. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. From a single broken spring to a full new door, we handle it.
Written by the team at Englewood Garage Door Repair Pros.