Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Englewood?
Spring repair in Englewood typically costs $180 – $340 for one spring. That range is the price to replace a single torsion or extension spring, and it’s the number most homeowners here actually pay. If both springs are replaced as a matched pair – which is what we usually recommend, since springs wear at the same rate – expect roughly double, so $360 – $680 for the pair. The written estimate sets the final price.
Call (833) 513-8729 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Springs are the one part of a garage door we never suggest a homeowner touches. A wound torsion spring holds enough stored energy to break a bone or worse when it lets go, and the danger is highest during removal, not during normal use. That’s why we treat spring replacement as its own specialty rather than an add-on to general repair. Our technicians have up to 11 years of experience with the exact spring systems in Englewood garages, and they work on the door’s brand and model rather than swapping in a generic substitute.
Spring Replacement Cost Breakdown (2026)
Here’s how spring work breaks down by job type in the Englewood market. These are typical estimated ranges, not a quote – every door is measured before we price it.
| Job | Typical Estimated Cost |
|---|---|
| Single spring replacement (one spring) | $180 – $340 |
| Matched pair of springs (both replaced together) | $360 – $680 |
| General garage door repair (springs fall within this broader band) | $150 – $600 |
| Cable repair (often done alongside a spring) | $130 – $250 |
| Roller replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| New door installation | $700 – $2,200 |
A single spring sits at the low end when it’s a standard torsion spring on a single-car door. The price climbs toward the top of the range for heavier double-car doors, high-lift setups, or when the spring sits in a tight spot that takes longer to reach safely. Extension springs on older doors can run a bit less than torsion springs on newer ones.
Why the pair usually matters
Springs on a two-spring door are matched at the factory and wound to balance the same weight. When one snaps, the other has usually lived the exact same number of cycles and is close behind. Replacing only the broken one means paying for a second visit shortly after. We price the pair clearly so you can decide, and the written estimate shows both options before any work starts.
What Affects Spring Replacement Pricing in Englewood
Five things move the number up or down on a typical Englewood job:
- Spring type and door weight. Torsion springs on the front of the door and extension springs along the tracks are priced differently, and a heavier insulated door needs a higher-cycle spring that costs more than a standard one. We measure the door’s actual weight rather than guessing from its size.
- One spring or a pair. This is the biggest single swing in the estimate. One spring runs $180 – $340; the matched pair about double. The pair is the usual recommendation on any door that carries two springs.
- What else the spring took with it. When a spring lets go, the cables, rollers or track can take the hit. Adding cable repair ($130 – $250) or roller replacement ($110 – $220) to the same visit keeps the total lower than booking two separate jobs.
- Age and brand of the door. Older doors sometimes need a specific spring size that isn’t the common one, and a few older Craftsman, Genie, Wayne Dalton and Raynor setups use hardware that has to be matched exactly. We carry the brands we know best – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor – so the repair matches what’s already on your door.
- Access and ceiling height. A low-clearance ceiling or a door tucked behind shelving adds time to set up safely. It’s a small factor, but it’s real, and it shows up in most estimates for tight garages.
- Whether the opener needs attention too. If the door has been fighting a weak spring, the opener may have been straining. Sometimes an opener repair ($120 – $320) makes sense on the same visit.
How to Save on Spring Replacement
Spring work isn’t a place to chase the cheapest bid – a bargain spring that’s undersized for the door will fail early and cost you again. But there are honest ways to keep the total down:
- Fix the pair in one visit. Replacing both springs together avoids a second service visit and a second setup. It’s usually the lower total over a year or two.
- Bundle related repairs. If the cables or rollers are worn, handle them in the same appointment instead of paying for two separate trips.
- Get the estimate in writing first. Free estimates mean you can compare the same job apples to apples. Call (833) 513-8729 and we’ll price it before we touch anything.
- Don’t wait for the second spring. If one has snapped, the second is often close. Catching it early avoids the emergency call and the chance of the door coming down out of balance.
- Ask about the spring’s cycle rating. A higher-cycle spring costs a little more up front but lasts longer, which is cheaper per year on a door you use every day.
One more saving that costs nothing: don’t try to lubricate or adjust a failing spring to buy time. If it’s already cracking or the door is hard to lift, the safe move is to stop using the door and call. The estimate is free and the price is set per job by the written estimate.
How a Spring Replacement Usually Goes in Englewood
Most jobs are a single visit. Our technicians measure the door, weigh it, and match the replacement spring to it – not to a generic guess. Then they release the tension on the old springs using the proper winding bars, remove them, and wind the new set to the door’s exact balance point. The door should feel light to lift by hand and stay put halfway up; that’s the test that tells us the spring is right.
If the cables look stretched or frayed while they’re in there, we flag it before finishing. Same for worn rollers or a track that’s drifted out of plumb. You get the whole picture in one estimate rather than discovering a second problem a month later. If the opener was straining against a bad spring, we check it too, since a chain, belt or screw-drive unit that’s been working too hard can wear out its gears.
If your door is already stuck open or closed, or you have a car trapped inside, that’s the time to call rather than wait. We treat emergency spring failures as a core part of what we do, not a premium add-on. Call (833) 513-8729. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Spring Cost versus Full Door Replacement in Englewood
A spring is a wear part – it fails, it gets replaced, the door keeps going. A door that’s otherwise sound almost never needs to be replaced because a spring broke. The math rarely points to a new door unless the panels, tracks and hardware are all shot, or the door is very old and parts are hard to match.
If you’re weighing it, the comparison is simple. Spring work runs $180 – $340 for one, or about double for the pair. A full new door installation runs $700 – $2,200. That’s a real gap, and it’s why we’ll tell you plainly when a spring fix is all you need. When a door is genuinely past it, the same company that fixes springs can supply and install a full new system – so you’re not hunting for a second contractor. You can read more about our full range of services on the Englewood Garage Door Repair Pros home page.
FAQs – Spring Replacement Cost
How much does it cost to replace a garage door spring in Englewood?
Replacing one spring in Englewood typically costs $180 – $340. A matched pair usually runs about double, so $360 – $680. The written estimate sets the final price. Call (833) 513-8729 for a free quote – estimates cost nothing.
Is it cheaper to replace one spring or both?
Both, almost always, on a door that carries two springs. One spring is $180 – $340, the pair is about double, but the pair avoids a second service visit and a second setup – and since springs wear at the same rate, the second one is usually close to failing anyway. Call (833) 513-8729 and we’ll price both options for your door.
Why does spring replacement cost more than a simple repair?
Spring replacement is priced higher than a basic fix because of the tools, the exact spring matching and the safety work involved – it’s the most dangerous repair on a garage door. A single spring at $180 – $340 is still well below a new door at $700 – $2,200. Call (833) 513-8729 for an exact quote.
Can I replace a garage door spring myself to save money?
No – a wound torsion spring stores enough energy to cause serious injury, and removal is the riskiest moment. It isn’t a job for a homeowner, even a capable one. A professional replacement at $180 – $340 per spring is the safe route. Call (833) 513-8729 and we’ll handle it.
Can you come today if my spring just broke?
Often, yes – same-day service is part of what we do, and a broken spring is exactly the call we prioritize. Pricing stays at the standard range ($180 – $340 for one spring), set per job by the written estimate. Call (833) 513-8729. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening.
Key Takeaways
- One spring replacement in Englewood typically costs $180 – $340.
- A matched pair usually runs $360 – $680 – about double – and is the usual recommendation.
- Cables, rollers and track issues are cheaper when fixed on the same visit.
- Spring work is a safety-first specialty, not a DIY repair.
- Estimates are free and the written estimate sets the final price.
Get Your Spring Replacement Priced
If your door won’t lift, feels heavy, or you’ve heard the bang of a spring letting go, don’t keep working the door – call us and we’ll price the fix before any work starts. We work with the brands your door actually has, from LiftMaster and Chamberlain openers to Clopay, Amarr, Wayne Dalton, Raynor and Craftsman doors, and we’ll tell you honestly whether it’s a spring, a cable or the opener that’s causing the trouble. Same-day and emergency service are part of the job, not an upsell.
Call (833) 513-8729 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Englewood market as of 2026. Englewood Garage Door Repair Pros offers free estimates – call (833) 513-8729.
Written by the team at Englewood Garage Door Repair Pros.
What Our Customers Say
"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Travis Ziegler"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Craig Bennett"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Laura Barrett